Shopping cart
There are no products in your cart.
Stronghold Chuck
SKU: OW2137

This chuck requires an adaptor with the same thread as your spindle.

This chuck comes complete with #2 jaws and 1-1/2" Jumbo Screw.

This heavy duty chuck is designed for large lathes (16" swing or greater) to provide maximum gripping power! 

The body diameter of this chuck is 4½" (the largest currently available in our chuck family).

The chuck weighs approximately 8 lbs (fully assembled with the No. 2 Jaws). It is considerably heavier than the Talon Chuck (3.5 lbs) or Oneway Chuck (4.5 lbs) which makes it a very desirable chuck for large size lathe owners who want an exceptionally powerful grip for turning larger pieces.

The Stronghold Chuck is operated by a key. Key operation provides two major advantages:

  • One handed operation
  • Solid holding power
  • 5 to 1 ratio assures powerful clamping

Note: If your lathe is less than a 16" swing, we recommend our Talon Chuck.


  • Single-Hand Key Operation
  • Our Patented Over-Extension Safety System
  • 4-Jaw Scroll Chuck
  • Rugged Base Jaw Design


A wide range of accessory jaws are available for this chuck to cover all your turning requirements.

The following Jaw sets are available for this chuck:

  • Spigot Jaws - smaller turnings
  • #3 and #4 Jaws - turning large bowls, vases etc
  • Jumbo Jaws - finishing the bottom of bowls, or holding odd shaped peices
  • Flat Jaws - make custom jaws and attach them to these plates
  • Collett Jaws - used to hold a large variety of round stock