Resin Calculator

River Table Resin Calculator

Estimate the mixed epoxy needed for the whole tabletop, including the river and any extra pour above or below the slabs.

Project measurements

Units
Full tabletop

Use the inside dimensions of the mould you’ll pour into.

River and open gaps

Measure the thickness of your slab. Leave the river length blank to use the full mould length.

How will you measure the width?

Divide the measured length into four equal sections. At the midpoint of each section, add up the widths of the river and any other open gaps at the same depth.

Extra pour over the full tabletop

Default is 0 below and 1/16 inch above the slab. If your slab does not sit flat on the bottom of the mould, enter the distance between the mould and the slab.

Allow extra for uneven edges and resin left in the mixing container.

Estimated resin needed

Enter your project measurements to see how much mixed epoxy the full tabletop requires.

Shop DEEP Resin 2:1

Estimate seal coats, deep cracks and voids you didn’t measure separately. For best results, please follow the resin’s pour-depth and mixing instructions.

Disclaimer. Black Forest Wood Co. offers no warranty, either expressed or implied, as to the reliability of the information contained herein and assumes no liability for loss or damage associated with use of this calculator.